ZPEnergy.com - Another Working All Magnetic Motor !?

The following was originally posted at: http://pub20.bravenet.com/forum/

Subject: Re: I have built a working model!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Name: Mikell
Date Posted: Aug 10, 03 - 2:37 AM

I am familiar with Howard Johnson and his model. However, you don't need to configure the magnets like he did. Here is what I did.

Think of a donut shaped object about three feet in diameter with the center hole about two feet in diameter. Ok, now this donut is made up of bar magnets all in a spiral formation. The bar magnets are placed on this donut at an angle so that all the positive ends point inwards but at a very slanted angle and curved all the way around the donut shape so you have a magnet covered three dimensional donut. Now this serves as the stator magnets. Now the armature magnets are on a bearing connected to a shaft that is fixed to the center of the donut where there is just air. These armature magnets are glued to a piece of plastic that is shaped like an hour glass that extends over the donut but the armature magnets are straight and are configured opposite one another so magnet 1 is positive pointing inward and the next one beside it negative pinpointing inwards and so on. This armature is three feet in diameter and is placed just over the stator magnets by 1 cm. It spins so fast that I can't even see the armature magnets! Also the air around the donut looks pink! I know that this sounds weird but it looks pink when the hour glass magnets are spinning and it smells like rain! Only no rain. Weird!

I think what makes it turn is the angled stator magnets spiraling positive ends all pointing inwards while curved which is in strong contrast to the straight magnets in an hourglass configuration with every other magnet positive and negative. The spiraling configuration directs the spinning hourglass shape of the armature magnets to go in a dedicated direction.

It really works and is the most exciting day of my life! I have something here. If I'm not careful when I go to stop it if I touch it with my bare hands I got shocked so bad it felt like a jolt from a capacitor! Now I use a brake pad to stop it.

Contact: Mikell at: javalinnn@hotmail.com
---------
Hello, Mikell:

I'm a fellow over-unity enthusiast. This is in regard to your message on Sterling Allan's Greater Things web-site:

http://freeenergy.greaterthings.com/Directory/Howard_Johnson_Motor/Mikell/

Many of us in the New Energy "community" find that scientists, engineers, and skeptical members of the public would probably accept longevity of continued operation under load as sufficient evidence that an O/U device such as a magnetic motor, probably works as claimed. In that case, it would operate beyond the known capacity of modern batteries, including the touted Lithium-ion Polymer type, fuel cells, or any other energy source, so that the counter-claim that there was a hidden input source, could not be made.

Now that you have a working magnetic motor, you may be aware that science and technology skeptics have claimed that, to date, running magnetic motors have eventually slowed down to a stop.

With due regard to bearing wear, the consequent danger of shorting due to rotor/stator contact - like a failing IC engine alternator - , and possible damage due to over-heating, have you run the motor for an extraordinary time period, say, for six months or more, with some sort of demanding load such as a weighted spinning disc, or frictional resistance, all without any external input from the grid, a battery, fuel cell, or other energy source?

With thanks,

Hal Ade Ottawa, ON.