Scalar Antenna Device
Date: Wednesday, September 05, 2007 @ 11:15:25 UTC
Topic: Devices


Important! I was given the following plans for what the person called a "Scalar Antenna", they claim this is a system able to harness free electrostatic scalar potential energy from the atmosphere, in the style Tesla devised, if built correctly. I want this information to get out as far and wide as possible.


Apparatus and method of conversion by condenser discharges applicable to both alternating and direct currents:

Below is an interesting article indicating that it is possible to collect free electrical energy from the atmosphere is indeed possible at only $10 What would you say if I told you it is possible to build an effective simple battery charger that has no moving parts, has no generator, works day or night, and has no solar cells? What if I told you this could be done with a few scrounged parts for which $10 would be an exorbitant price? Just about every Ham operator knows better than to disconnect an antenna and then pick it up later by the connector and touch a ground. Enormous charges can build up on an insulated wire and the longer the wire the more charge that will build. Most all of us have learned to pick up the coax and tap or hold the antenna against the case of the radio to bleed off this charge. How few of us have ever been so poor as to have to think about how they can use this free energy. A friend told me how to do this a few years ago. When he was a kid in the depression, buying batteries to listen to his homebrew 2 tube regen radio was out of the question. So they used the long wire antenna they had scrounged from an old telegraph line to charge the batteries so they could listen to the radio. What Wiley did at the rip old age of 12 or 13 was hook a sparkplug to the end of the wire and then run the ground end (where the threads are) into a 12 volt coil off an old A model, but any old coil will do. The bottom connector of the coil that used to go to the points is hooked to the positive side of the battery. The negative side of the battery is hooked to a good earth ground and a 1 to 3 KV capacitor (a few picofarred type like those found in the horizontal section of a television chassis) is hooked from ground back to the wire where the top of the sparkplug is connected. That's it! Nothing should be touching ground except the ground post of the battery. Wiley was using about 200 feet of insulated wire and it will completely charge a 12 volt deep cycle every 2 or 3 days! A thousand feet of wire will do it a lot quicker but the voltages approach lethal levels. What is behind this feat is that a very long wire acts like a capacitor and builds a charge on the wire. When a few thousand volts are reached, it will discharge by "sparking" across the sparkplug. The sparkplug delivers the charge to the coil that downconverts it to a few hundred volts and pulses the battery, kind of "squirting" a charge into it. The weather controls how much static electricity is in the air. Wind and super cold air seem to really make you think you can weld with this thing! I hooked a small neon bulb to a full wave loop on winter nigh when it was snowing with a high wind and the bulb burned continuously all night long! The higher you get the wire of the ground the better. The wire has to be completely insulated. It doesn't seem to make any difference whether you lay it out in a straight line or weave it back and forth. Length is the thing here, not size. Old phone wire, old coax from the cable company, anything that is insulated and long will do the job. I use my Ham radio antennas, as they are up and long already. This thing will weld the fillings in your teeth together if you are not careful with it! The slides on the left illustrate this idea more fully.








This article comes from ZPEnergy.com
http://www.zpenergy.com

The URL for this story is:
http://www.zpenergy.com/modules.php?name=News&file=article&sid=2534