Earth Natural Electromagnetic Induction
This is what is happening, for right now I’m calling this Earth Electromagnetic induction zones they could be related to telluric currents or combination of both.
I been following energy devise specially self-looped system for some time now and some of these systems acted similar to my system that starts at low frequency.
People with OU devises should check for skin effects on any motors
and transformers that they have lying around, with there energy devise
running and not running. If you have skin effect, that tells you that
its man made or you are in Electromagnetic induction zone.
Take
your digital and analog multimeters and set them to mV. Also check the
energy devises that are being used. Make sure power is disconnected from
the energy devises.
If you have a newer cell phone that
uses apps you can down load magnetometer app. I don’t know how good they
are, but it’s worth a try.
Another test is to take a
diode or a bridge rectifier connected to the motor or transformers that
you have laying around and reverse polarity to the capacitor and let it
set for a while, before taking a reading. I did this and had good
results.
The induction zones are highly concentrated and
some of them are very large in size and small in size in places, on
earth, which these zones would be based on the physical make up of the
geographic area.
We need to chart OU Devises locations
with out reveling the inventor’s location. This could help in
understanding these Electromagnetic fields structures. And this could
explain other OU Devises.
This is going to change people’s point of view on how OU devises access external energies.
When
I started my pulse motor up, it ran normal as I expected. But after it
was running I was getting sound effects from the pulse motor. The way it
sounded was it was trying to speed up. Well I listened for awhile to
the sounds and I decided, maybe it was back EMF that was causing this.
So I decided to hook up a transformer that I removed from a microwave
oven, using the primary side only, to see if it had any effect. Well, it
did have an effect on it, more than I bargained for. It was like
plugging it into an AC outlet. This setup was very basic setup, nothing
special to it. No diodes or capacitors or any other electronic
components. My pulse motor, consisted of 21 ceramic magnets mounted on a
steel flywheel, one hand made pulse coil, and one HV transformer and
one relay for switching. The relay coil was not being used and 12VDC car
battery that was bad. This was too simple.
I could tell more but I think you get the message.
Don’t ignore this.
